Dies ist eine alte Version des Dokuments!
CentOS 4 / Redhat Enterprise Linux 4 iSCSI Installation and Configuration ( iscsi initiators )
by Vivek Gite on May 13, 2008
I've received a couple of email about setting up iSCSI under CentOS 4 or RHEL ES 4 server. Previously, I wrote about iSCSI under CentOS 5 / RHEL 5 server. Requirements
[a] Following instructions tested on RHEL ES 4 and CentOS 4 only. (See RHEL 5/ CentOS 5 / Debian/ Ubuntu Linux specific instructions here). [b] You need following information [c] ISCSI Username [d] ISCSI Password [e] ISCSI Server IP / hostname
CentOS Linux v4.x - Install iscsi-initiator-utils
Type the following command:
# yum install iscsi-initiator-utils
Redhat ES Linux v4.x - Install iscsi-initiator-utils
Type the following command:
# up2date iscsi-initiator-utils
Configure iSCSI
Open /etc/iscsi.conf file, enter:
# vi /etc/iscsi.conf Setup it as follows: DiscoveryAddress=ISCSI_TARGET_HOST_OR_IP OutgoingUserName=ISCSI_USER_NAME OutgoingPassword=ISCSI_PASSWORD LoginTimeout=15 Save and close the file.
Start the iscsi service
Type the following command to start iscsi service so that you can see block device:
# chkconfig iscsi on # /etc/init.d/iscsi start
Run any one of the following to find out new block device name:
# fdisk -l # tail -f /var/log/messages # find /sys/devices/platform/host* -name "block*"
Format iSCSI device
Use fdisk and mkfs.ext3 commands. First, create a partition (assuming that /dev/sdc is a new block device assigned to iscsi) :
# fdisk /dev/sdc # mkfs.ext3 /dev/sdc1
Create /mnt/iscsi directory:
# mkdir -p /mnt/iscsi
Open /etc/fstab file and append config directive:
/dev/sdc1 /mnt/iscsi ext3 _netdev 0 0
Save and close the file. Mount the parition /dev/sdc1:
# mount -a # df -H